TEFAL IS3380 Manual page 14

Problems
Water runs through
the holes of the steam
head.
The steamer takes
a long time to heat
and/or ejects white
particles.
The Press & Steam
accessory is crooked.
The Press & Steam
accessory detaches
while in use.
The hose makes a
gurgling noise.
Water is overflowing
from water tank.
If you have any further problems or queries please contact the Customer
Relations Helpline - see details at the end of this leaflet.
12
Possible causes
There is condensation in
the hose.
Your steamer has a build-
up of scale because it
has not been descaled
regularly.
The Press & Steam
accessory has not been
assembled properly.
The Press & Steam
accessory has not been
rolled properly.
The Press & Steam
accessory was not locked
correctly in the hook.
You are using the steam
head in a position close
to the ground and some
condensation occurs in
the hose.
You are using the steam
head in a position close
to the ground and some
condensation occurs in
the hose.
Solutions
Never use the steamer in the horizontal
position. Hold the hose vertically
outstretched and wait for the condensed
water to return to the steamer.
Follow the «easy descaling» process
Reassemble the Press & Steam accessory
inside the integrated hanger.
Make sure it is properly hooked in place by
following the instructions.
Make sure the Press & Steam accessory
is always dry then rolled with care when
stored. Do not crease it for storage.
Make sure the Press & Steam accessory
handle is firmly locked in the hook. It should
not be moving horizontally or vertically.
Make sure the 4 segments of the pole are
fully extended and that the 3 clips are firmly
locked.
Raise the hose frequently during use
and adjust the pole to its maximum
height in order to avoid the formation of
condensation.
Raise the hose frequently during use
and adjust the pole to its maximum
height in order to avoid the formation of
condensation.
* depending on model