Dry Vacuum Operation - Vacmaster VJ607-1 Operator's Manual

DRY-VACUUM OPERATION
DRY VACUUMING
WARNING:
BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION, ENTITLED 'SAFETY
INSTRUCTIONS & WARNINGS'. DO NOT VACUUM IN AREAS WITH FLAMMABLE GASES, VAPORS,
OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS INCLUDE BUT ARE NOT
LIMITED TO; LIGHTER FLUID, SOLVENT TYPE CLEANERS, OIL-BASE PAINTS, GASOLINE,
ALCOHOL OR AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO;
COAL, MAGNESIUM, GRAIN OR GUN POWDER. TO REDUCE THE RISK OF HEALTH HAZARDS
FROM VAPORS OR DUST, DO NOT VACUUM TOXIC MATERIALS.
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. In order to prepare your vacuum for dry vacuuming, make sure the filter is completely covering the filter
cage against the power head. (fig. 2 & 3) (Your Wet/Dry Vac comes with the reusable cloth filter pre-
installed, if not, see page 10 for installation instructions.)
3. Place the power head section back on the container, and secure it in place using the latches. (fig. 4)
OPERATING INSTRUCTIONS: DRY VACUUMING
4. Insert the locking end of the hose into the vacuum port on the power head and lock in place. Push the
required attachment onto the free end of the hose or extension. (fig. 5)
5. Plug in the power cord into the outlet. (fig. 6)
6. Turn the motor on by pressing the switch to the 'I' ON position. (fig. 7)
7. Once you have completed vacuuming, press the switch to the 'O' OFF position and unplug the power cord
from the outlet.
DO NOT USE THE DUST FILTER FOR LIQUID VACUUMING.
O = OFF I = ON
7