Use Your Baby Monitor; Operating Range - Philips SCD485/24 User Manual

5 Use your baby
monitor
1
Press on the parent/baby unit.
» The parent/baby unit turns on, and all
indicators on the parent/baby unit light
up briefly.
2
Keep the baby unit and the power cord at
least 1 metre/3.5 feet away from your baby.
3
Use the parent unit in the operating range.
4
Set the parent unit and the baby unit to
the same channel, either Channel 1 or
Channel 2.
» The link indicator flashes red and the
parent unit starts to search for the
baby unit.
» When link is established, the link
indicator lights up green.
» If no link is established, the link
indicator flashes red. The parent unit
beeps from time to time.
5
To change the volume on your parent unit,
turn volume up or down.
To mute the volume, turn volume
•
down fully. When the volume is
muted, the sound level lights operate
as normal.
Tip
•
Your baby monitor is specially designed to conceal the
antenna in the top part of the parent unit. To avoid
obstructions that may reduce the operating range, hold
the parent unit at the base when carrying it.
•
When the parent unit is out of range of the baby
unit, the parent unit beeps from time to time. The link
indicator on the parent unit flashes red.
•
The battery indicator flashes red and a beep tone
occurs 30 minutes before the batteries run out of
power. When the batteries are completely empty, the
parent unit automatically switches off and loses the link
with the baby unit.

Operating range

• Outdoors: up to 150 metres/500 feet
• Indoors: up to 50 metres/150 feet
• This monitor is designed to operate at
its best within a 150 m range, suitable
for most household environments.
The operating range and quality of the
connection varies depending on the
number of obstructions, like walls or
buildings, in between the two units.
Link an additional parent unit
You can use multiple additional parent units
with your baby monitor. Follow the simple two
steps to link extra units.
Note
•
Use the parent unit in the operating range of the baby
monitor.
1
Press on the additional parent unit.
» The parent unit turns on, and all
indicators on the parent unit light up
briefly.
2
Set the parent unit and the baby unit to
the same channel, Channel 1 or Channel 2.
» When link is established, the link
indicator lights up green.
EN 9