Preparing For Use; Baby Unit; Parent Unit; Using The Baby Monitor - Philips Avent SCD734 User Manual

Hide thumbs Also See for Avent SCD734:
Table of Contents


Preparing for use

Baby unit

Parent unit

Using the baby monitor

Positioning the baby monitor

IMPORTANT: Read the safety instructions carefully before you use
the baby monitor and keep them for future reference.
We advise you to use the baby unit connected to the mains To guarantee
automatic power backup in case of mains failure, you can insert four
1.5V AA alkaline batteries (not included).
Do not use rechargeable batteries The baby unit does not have a
charging function and rechargeable batteries discharge slowly when they
are not in use
The parent unit runs on two rechargeable batteries that are supplied with
the baby monitor. Charge the parent unit before you use it for the first
time and when the batteries are low
Please note that for the SCD730 / SCD731/ SCD733/xx, you
have to charge the parent unit for the full 10 hours to have a
cordless operating time of 18 hours. For the SCD734 / SCD735 and
SCD733/26: the charging time is 14 hours and the operating time is
25 hours.
Note: When you start using the baby monitor, it takes 4 charge and
discharge cycles before the rechargeable batteries reach their full
Keep the baby unit out of the reach of the baby. Never place
the baby unit inside the baby's bed or playpen.
Because the cord of the baby unit presents a potential strangulation
hazard, make sure that the baby unit and its cord are at least
1 metre/3.5 feet away from your baby.
To prevent a high-pitched sound from one or both units, make sure
that the parent unit is at least 1 metre/3.5 feet away from the baby
- 4 -


Table of Contents

Table of Contents