DAVIS 6322C User Manual page 30

Installing the ISS and Anemometer on a Pole
Built-in bubble level
behind tipping spoon mechanism
Tipping spoon not
shown for clarity.
Rain Collector
Mounting Base
When installing the ISS on a pole, the rain collector /radiation shield section of the
ISS and the anemometer can be mounted together as a single unit, or the two
sections can be mounted separately.
Accessories for Pole Mounting
• Use the Mounting Tripod (#7716) for easy roof-mounting.
• Use the Mounting Pole Kit (#7717) to raise the installation height of the ISS by
up to 37.5" (0.95 m).
General Guidelines for Installing on a Pole
• With the supplied U-bolts, the ISS and anemometer can be mounted on a pole
having an outside diameter ranging from 1
• Larger U-bolts (not supplied) can be used to mount to a pole with a maximum
outside diameter of 2
• To mount on a smaller pole, obtain a U-bolt that fits the ISS base openings but
that has a shorter threaded section. If mounting on a smaller pole with the
included U-bolts, the bolt interferes with the rain collector cone. The pole must be
sturdy enough to be stable. Any movement of the pole will affect wind and rain
data.
• Use the built-in bubble level to ensure ISS is level.
28
1/4" Hex Nut
1/4" Lock Washer
Backing Plate
Groove for
U-Bolt
1
/ " (64mm).
2
U-Bolts:
Anemometer U-Bolt Rain Collector U-Bolt
1 3
/ " to 1
4
1/4" Flat Washer
1/4" Lock Wash
Anemometer
Mounting Base
/ " (32 – 44mm).
4
1/4" Hex Nu