Sample Port Trigger Entries - Motorola Wireless Broadband Routers WR850G User Manual

Motorola wireless broadband routers user guide

Hide thumbs Also See for Wireless Broadband Routers WR850G:

User manual (93 pages)

Firmware release notes (14 pages)

Troubleshooting (4 pages)

Table Of Contents

Table of Contents

Section 3

To add a Port Trigger entry:

Enter the name of the application in the Port Trigger Name field. There is a limit of 32

characters for the name.

Click enable if you wish the port trigger to become active immediately. Otherwise, you

can save the information and enable it at later date.

To enable at a later date, select the entry, check enable, and then click Add.

From the Outgoing Protocol drop-down list, select TCP or UDP.

In the Outgoing Port fields, enter the From and To ranges (0 to 65535) for your

application.

From the Trigger Inbound Protocol drop-down list, select TCP or UDP.

In the Incoming Port field, enter continuous value(s) (0 to 65535), separated by dashes,

for your application. You can also enter multiple non-continuous values, separated by

semicolons.

In the Idle Time fields, enter the elapsed time before the Port Trigger mapping closes

for all of the listed entries.

Click Apply to save your settings. To cancel your changes, click Cancel.

To edit or remove an entry, select it and then click Edit or Remove to perform the

action.