Installing The Canopy Housing - Fanimation Distinction C1 Series Owner's Manual

NOTE: This step is applicable after the necessary wiring
is completed.
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy housing
and not pinched between the housing and the ceiling.
1A. For Downrod Fans
Slide the ceiling canopy over the mounting bracket
with the two loosened screws going into the "L" slots
in the canopy. Be sure all wiring is tucked into the
ceiling canopy and is not pinched. Once the canopy
is flush with your ceiling, turn clockwise to seat the
screws into the keyed portion of the slot. Tighten the
screws. (Figure 1)
1B. For Close-to-Ceiling Fans
Mount your fan by sliding the ceiling canopy over
the mounting bracket with the two loosened screws
going into the "L" slots in the canopy. Be sure all
wiring is tucked into the ceiling canopy and is not
pinched. Once the canopy is flush with your ceiling,
turn clockwise to seat the screws into the keyed
portion of the slot. Tighten the screws. (Figure 2)
2. Install the remaining two screws removed in
step 7 of page 8 to secure the ceiling canopy to
the ceiling bracket.
Push the canopy trim cover assembly up to
3.
conceal the screws, such that the mounting tabs
seat into the dimpled grooves in the ceiling canopy
midway between the screws.

Installing the Canopy Housing

(Figure 3)
(Figure 4)
Hanger
Bracket
Ceiling Canopy
NOTE: MOTOR WIRES
HAVE BEEN OMITTED
FROM DIAGRAM
Hanger
Bracket
Ceiling Canopy
Dimpled
Groove
13
Screw
" L" Slot
NOTE: MOTOR WIRES
HAVE BEEN OMITTED
Figure 1
FROM DIAGRAM
Screw
" L" Slot
Figure 2
Figure 3
Mounting
Tabs(4)
Canopy Trim
Cover Assembly
Figure 4