Skyrc D100 V2 Instruction Manual page 18

Lithium Battery Program
BATTERY CHECK
WAIT...
R:3SER S:3SER
CANCEL(STOP)
R:3SER S:3SER
CONFIRM(ENTER)
START/ENTER
Lp3s 1.5A 12.14V
BAL 000:50 00022
[ END: FINISH ]
16.8V 2600mAh
[ Time: 00: 45: 32 ]
16.8V 2600mAh
Program Stop
During the charging process, press STOP to stop the charging process.
· 16
The charger is detecting the battery cell.
R shows the number of cells detected by the charger and S is
the number of cells set by you on the previous screen. If the
two numbers are not identical, press STOP to go back to the
previous screen to recheck the number of cells of the battery
pack that you set before going ahead.
R shows the number of cells detected by the charger and S is the number
of cells set by you on the previous screen. If the two numbers are identical,
press START/ENTER to start the charging process.
Charging Status Monitor
During charge process, real-time status will be shown as seen on the left.
Program Complete
Once the battery is fully charged, the screen will read "END:
FINISH" and the charger will emit a ringing sound. The charger
also displays battery voltage, charged capacity and elapsed time.
(LiPo/LiFe/Lilon/LiHV)
D100 V2