Fault Finding - Koolbreeze Climateasy 12NG Manual

FAULT-FINDING
If the CLIMATEASY 12NG is not operating, proceed as
follows:
Check that the mains plug is firmly in the socket, and that the
socket is switched ON.
When the unit is switched on there will be a delay of up to 3.5
minutes before it starts to operate.
 Unit stops running:
Mains supply is disconnected or has failed
Target temperature has been reached.
Timer has been set.
Water tank is full (WATERFULL indicator will illuminate)
 In cooling mode, no cool air is produced:
Room temperature is lower than set temperature
The unit is defrosting (this will take a few minutes, and
afterwards, it will resume operation)
Filter is blocked
 Cooling is poor on hot days
Too much direct sunshine is heating the room
Windows or doors are open allowing hot air into the room
A lot of people in the room (each person contributes about
75W of heating)
Electrical equipment in the room producing heat
 Heating is poor on cold days
The heat pump can only heat effectively when the outdoor
temperature is above 7 °C. The unit is not intended as a
primary means of heating premises.
 Remote control does not work:
Check batteries are correctly installed, and are not exhausted.
Make sure that the remote control is pointed towards the main
unit when being used.
Page 12