Table of Contents
Advertisement
Chapter 12
•
WMM
transmitted preferentially.
•
Short GI
capacity by reducing the guard interval time.
•
AP Isolation
stations cannot access each other through WLAN.
•
Airtime Fairness
sacrificing a little bit of network time on your slow devices.
•
Zero Wait DFS
immediately reselect a new channel once the radar signal is detected on a channel
allocated to radar devices to ensure lag-free network experience.
•
Beacon Interval
duration between beacon packets that are broadcasted by the router to synchronize
the wireless network. The default value is 100 milliseconds.
•
RTS
data transmission through the router. By default, the RTS (Request to Send) Threshold
size is 2346. If the packet size is greater than the preset threshold, the router will send
RTS frames to a particular receiving station and negotiate the sending of a data frame.
•
DTIM Interval
Message). Enter a value between 1 and 15 intervals. The default value is 1, which
indicates the DTIM Interval is the same as Beacon Interval.
•
Group Key Update Period
time interval for the encryption key automatic renewal. The default value is 0, meaning
no key renewal.
Downloaded from
ManualsNet.com
- WMM function can guarantee the packets with high-priority messages being
- It is recommended to enable this function, for it will increase the data
- This function isolates all connected wireless stations so that wireless
- This function can improve the overall network performance by
- Zero Wait DFS (Dynamic Frequency Selection) allows the router to
- Enter a value between 40 and 1000 in milliseconds to determine the
Threshold- Enter a value between 1 and 2346 to determine the packet size of
- The value determines the interval of DTIM (Delivery Traffic Indication
- Enter a number of seconds (minimum 30) to control the
search engine
Customize Your Network Settings
70
Hide quick links:
Advertisement
Table of Contents
