TP-Link Archer AX10 User Manual page 13

Chapter 2
Note:
Note: If the 2.4GHz LED and 5GHz LED are off, press and hold the WPS/Wi-Fi button on the back for more than 2 seconds,
then release the button. Both the LEDs should turn solid on.
5. Connect your computer to the router.
• Method 1: Wired
Turn off the Wi-Fi on your computer and connect the devices as shown below.
• Method 2: Wirelessly
1 ) Find the SSID (Network Name) and Wireless Password printed on the label at
2 ) Click the network icon of your computer or go to Wi-Fi Settings of your smart
• Method 3: Use the WPS button
Wireless devices that support WPS, including Android phones, tablets, and most USB
network cards, can be connected to your router through this method.
Note:
• WPS is not supported by iOS devices.
• The WPS function cannot be configured if the wireless function of the router is disabled. Also, the WPS function will be
disabled if your wireless encryption is WEP. Please make sure the wireless function is enabled and is configured with
the appropriate encryption before configuring the WPS.
1 ) Tab the WPS icon on the device's screen. Here we take an Android phone for
2 ) Within two minutes, press the WPS button on your router.
Downloaded from ManualsNet.com
the bottom of the router.
device, and then select the SSID to join the network.
Computer
Connections are available
Wireless Network Connection
TP-Link_XXXX
TP-Link_XXXX_5G
Connect automatically
instance.
search engine
Ethernet cable
< Settings
Wi-Fi
CHOOSE A NETWORK...
OR
TP-Link_XXXX
Connect
TP-Link_XXXX_5G
Other...
Connect the Hardware
Smart Device
Wi-Fi
9