Hardware Setup; Setup Hardware - Kodicom DigiNet Center User Manual

10.1 Hardware setup

Camera setup
Camera setup
1
2
1
[Setup]
• Check on the camera you want to use.
2
[Name]
• Put the name of the place where you installed camera.
Ex) Parking lot, entrance etc. (up to 14 characters)
3 [Sensor]
• DigiNet has a motion detection function.
You can attach external sensors from 8 to 16.
• If the related external sensor starts working, connected
camera starts recording.
• Input the sensor number you wish to use (Sensor
number that's related with each camera).
• If there are a few cameras, you can separate by comma.
• This is not required on motion detection mode.
Ex) If you want to store an image from number 1 camera
while number 2 and number 3's external sensor is
working, input "2,3" on number 1 camera's "Link sensor"
list.
5
3 4
4
[Recording with Motion Detected channel]
• When a camera detects any movement, system records
it's linked channel as well.
• From "Recording Schedule" tap, record setting must be
under Motion Detection mode for inputted specific camera
number. If it is set on 'Continuous recording', this function is
not activated.
• Input camera number of related camera that will detect
and record related motion at the same time.
Ex) When camera number 1 and number 2 capture any
motion and you also want camera number 3 to record it as
well, just input "1,2" to "Related Motion" blank space under
camera number 3.
5 [P/T]
• Check this when you use PAN/TILT camera.
• Selected camera has <Pan/Tilt> on top of the image.