Table of Contents
Advertisement
9.1 How to Control PAN/TILT Mode
1
Display current date and time
[POWER]
2
• camera power
[WIPER]
3
• camera wiper
4
[LIGHT]
• camera light
[AUTO]
5
• On/Off of the AUTO PAN/TILT camera
6
[PAN/TILT control]
• controls up, down / left . right
7
[FOCUS]
• controls focus
(This is not used for auto focus lens.)
[Tip]
☞
You need the same number of RX RECEIVER(KRE-301 or KRE-302) to control PAN/TILT camera.
10
8
[ZOOM]
• controls ZOOM
[DIS]
9
• This is used to go back to surveillance mode
from PAN/TILT mode.
[Go-To]
10
Dome camera moves to the configured position on
each buttons in "Go-To".
• To activate "Go-To" function you need to
click
like this.
the desired position and click the number to
assign to
This can be only used when PAN/TILT type (that is
applied to site) supports [Go-To] function (Most Speed
Dome camera support this function but some models will
not support.
This function will not work with normal RX Receiver.
1
2
3
4
5
6
7
8
9
, then 'set-up' button will look
Then, move the camera to
Advertisement
Table of Contents
