Related Manuals for Clarke Contractor CROS2
Summary of Contents for Clarke Contractor CROS2
- Page 1 VARIABLE SPEED JIG SAW RANDOM ORBITAL SANDER RANDOM ORBITAL SANDER Part No. 6460200 MODEL No. CROS2 Part No. 6462011 OPERATING & MAINTENANCE INSTRUCTIONS 0307...
-
Page 2: Specifications
Please note that the details and specifications contained herein, are correct at the time of going to print. However, CLARKE International reserve the right to change specifications at any time without prior notice. -
Page 3: Safety Precautions
SAFETY PRECAUTIONS WARNING: As with all machinery, there are certain hazards involved with their operation and use. Exercising respect and caution will considerably lessen the risk of personal injury. However, if normal safety precautions are overlooked or ignored, personal injury to the operator or damage to property, may result. ALWAYS Learn the machines applications, limitations and the specific potential hazards peculiar to it. -
Page 4: Dust Extraction
16. ALWAYS have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. 17. NEVER operate machine while under the influence of drugs, alcohol or any medication. 18. -
Page 5: Electrical Connections
Should you wish to replace a detachable fuse carrier, ensure that the correct replacement is used (as indicated by marking or colour code). Replacement fuse covers can be obtained from your local Clarke dealer or most electrical stockists. Fuse Rating The fuse in the plug must be replaced with one of the same rating (13 amps) and this replacement must be ASTA approved to BS1362. -
Page 6: Dust Collection
PREPARATION Fitting Sanding Disk Note : Only use disks which have a velcro fixing capacity on the rear. a) Ensure sander is switched OFF and plug is removed from mains socket. b) Line up holes in disk with those on the machine pad. (This is necessary for dust extraction), press disk firmly on to pad to secure it. -
Page 7: Operation
OPERATION Insert the plug into the mains socket and switch on. Hold the sander firmly with both hands and squeeze the trigger switch. To switch the sander off, release the trigger switch. Lock On Button The trigger switch can be locked for continuous sanding. -
Page 8: Troubleshooting
Refer to qualified service personnel if internal maintenance is required. ACCESSORIES A wide range of accessories is available from your nearest CLARKE dealer, for further information, contact your nearest dealer, or telephone CLARKE International Sales department on 01992 565300... -
Page 9: Parts List
PARTS LIST e l l & i - l i Replacement sanding discs are available from your CLARKE dealer. PARTS & SERVICE TEL: 020 8988 7400 or e-mail as follows: PARTS: Parts@clarkeinternational.com SERVICE: Service@clarkeinternational.com... -
Page 10: Parts Diagram
PARTS DIAGRAM... -
Page 11: Vibration Emissions
VIBRATION EMISSIONS HAND-ARM VIBRATION Employers are advised to refer to the HSE publication “Guide for Employers”. All hand held power tools vibrate to some extent, and this vibration is transmitted to the operator via the handle, or hand used to steady the tool. Vibration from about 2 to 1500 hertz is potentially damaging and is most hazardous in the range from about 5 to 20 hertz.
Need help?
Do you have a question about the Contractor CROS2 and is the answer not in the manual?
Questions and answers