Table of Contents
Advertisement
CLEAN-UP
• Disconnect air supply to Gun.
• Remove Material Cup and pour all the unused coating possible into the original or proper
container.
• Reconnect air supply to Gun.
• This Gun is designed with a Self-Clearing feature. To activate:
- Direct the Nozzle or attached Wand Nozzle into a safe area or vessel.
- Pull the Trigger half-way to purge any leftover material from the Gun interior,
Nozzle and/or attachment Wand.
• Disconnect air supply to gun.
• Remove Material Cup.
• Wipe out any excess coating then thoroughly rinse the Material Cup with a mild solvent
compatible with the coating being used.
DO NOT use Lacquer Thinner or other harsh solvents as they may damage
the seals in the Gun!
• Pour a small amount of mineral spirts, #10194ZP, Eastwood PRE Painting Prep, acetone or a
solvent compatible with the material being used in the Material Cup then re-attach the Material
Cup, run solvent through the Gun in a safe area until it flows clear.
• Remove air supply from the Gun.
• Pour out any unused solvent and remove the Material Cup.
Follow Federal and Local Hazmat regulations and collect used solvent for
proper disposal.
• Unthread and remove the Spray Head Ring [K].
• Using a wrench (not included) on the flats, gently unthread the Spray Head [L].
• Dip a brush in solvent and gently clean any coating present.
• Allow solvent to dry completely from all components.
• Reinstall Spray Head and Ring.
To order parts and supplies: 800.343.9353 >> eastwood.com
9
Advertisement
Table of Contents
