Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Eastwood CONCOURS 2 16287
Summary of Contents for Eastwood CONCOURS 2 16287
- Page 1 Item #16287 CONCOURS 2 PAINT GUN & ACCESSORY KIT INSTRUCTIONS...
-
Page 2: Specifications
The Eastwood Concours 2 HVLP Paint Gun is a precision engineered gun designed for use by the seasoned professional or hobbyist. It is capable of producing a high-quality paint finish and will provide many years of trouble free service. The body is constructed of a highly durable and lightweight alloy with Stainless Steel internal components which are compatible with both solvent and water borne coatings. -
Page 3: General Safety Rules
• Use only Eastwood Aerosol Injected Cleaner, acetone or lacquer thinner to clean guns. Use of chlorinated or halogenated hydrocarbon solvents can corrode aluminum gun components or emit hazardous reactive gasses. - Page 4 • Clean out the paint cup as well as the paint gun air and paint passages with a solvent such as Eastwood PRE or acetone to remove any residual manufacturing impurities before use. Dry thoroughly.
- Page 5 Control achieved your optimal knob settings, note their Retaining Ring positions with the indicators on the gun body and knobs. This will assist in quickly “tuning” the gun in future uses. Control To order parts and supplies: 800.343.9353 >> eastwood.com...
- Page 6 • Pour a small amount of a solvent compatible with the paint being used in to the Paint Cup then attach Paint Cup, run solvent through HVLP Gun in a safe area until it flows clear. As an alternative, # 12846Z Eastwood Aerosol Injected Gun Cleaner is excellent for this purpose.
- Page 7 10mm wrench (do not-over tighten). • Replace Air cap by threading Tension Retaining Ring onto Gun Spring Body. Make sure the air horns of the Air Cap are FIG. 7 oriented properly. Needle Tension Spring To order parts and supplies: 800.343.9353 >> eastwood.com...
-
Page 8: Troubleshooting
Speed up gun motion over surface too slowly over surface Excessive runs and sags Excessive fluid Decrease fluid flow by adjusting “fluid” knob flow Paint mixed too Check paint manufacturer’s reducing/thinning thin instructions Eastwood Technical Assistance: 800.343.9353 >> techelp@eastwood.com... - Page 9 Paint spray is Needle tip or sputtering Replace Needle/Nozzle set Nozzle seat damaged Gun being tipped Operate gun with tip tilted no more than 45º down too far down or up To order parts and supplies: 800.343.9353 >> eastwood.com...
- Page 10 Increase inlet air pressure at gun too low Exaggerated “Football” Fluid flow Decrease fluid flow adjustment on gun shaped spray adjusted too high pattern Check paint manufacturer’s mix ratio Paint mixture too instructions or thin if possible thick Eastwood Technical Assistance: 800.343.9353 >> techelp@eastwood.com...
- Page 11 To order parts and supplies: 800.343.9353 >> eastwood.com...
-
Page 12: Additional Items
Gerson OneStep Respirator If you have any questions about the use of this product, please contact The Eastwood Technical Assistance Service Department: 800.343.9353 >> email: techelp@eastwood.com PDF version of this manual is available online >> eastwood.com/16287manual The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA US and Canada: 800.343.9353 Outside US: 610.718.8335...