Table of Contents
Advertisement
SAFETY INFORMATION
INITIAL SET-UP
• Remove all components from carton, identify them and become familiar with their purpose.
• A 3/8" I.D. minimum air hose at a 25' maximum length is strongly recommended for best
results. Smaller I.D. hose and greater length may reduce available CFM and produce
unsatisfactory results.
• A clean, dry, regulated air supply is required. The use of an additional "on the gun" regulator
is strongly recommended to accurately control gun inlet air pressure while applying material.
• Clean out the fluid cup as well as the gun air and material passages with a solvent such as
Eastwood PRE or acetone to remove any residual manufacturing impurities before use.
Dry thoroughly.
4
• This Undercoat Gun can quickly spray when handling while connected to an
air supply causing serious personal injury. Always disconnect the Gun from
the air supply before adding material, changing nozzles, removing clogs or
other maintenance.
• Use only Eastwood PRE, acetone or mineral spirits to clean Gun and Nozzles.
Use of lacquer thinners or chlorinated or halogenated hydrocarbon solvents
can corrode aluminum gun components, damage seals or emit hazardous
reactive gasses.
• Use for spraying undercoating, bedliner and rustproofing products only.
Do not use for spraying pesticides, fertilizer, acids or other corrosive
materials and solvents.
• Follow Federal and Local Hazmat regulations and collect used solvent for
proper disposal.
Eastwood Technical Assistance: 800.343.9353 >> tech@eastwood.com
INJURY HAZARD!
Advertisement
Table of Contents
