If an extension cord is required, a 25' cord is recommended not to exceed 50'. All extension cords must be 14 AWG or greater. • Always unplug Turbine Unit before refi lling gun cup, cleaning or servicing the Paint Gun’ Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com...
The Eastwood 5-Stage Electric Turbine HVLP Paint System is a powerful 5-Stage, fully self-contained, lightweight unit that provides clean, dry, warm air to the HVLP type spray gun specifi cally designed to withstand the demands of the avid hobbyist and semi-professional. The true HVLP type gun design is fully certifi...
Page 4
The Blanking Screw Eastwood Turbine Gun is assembled with a 0.8mm Needle/Nozzle set and Air Cap as standard. All others denoted by *(1.0mm, 1.3mm, 1.5mm & 1.8mm) are available separately.
• When between coatings or when fi nished spraying, turn off the Turbine Unit as soon as possible. Failure to do so can overheat the motor and cause permanent damage. To order parts and supplies: 800.345.1178 >> eastwood.com...
Page 6
NOTE: Make sure you reassemble the two pieces correctly or you will not have any fan pattern adjustment. 7. Remove the Fan Adjustment Seal (Fig Q). Clean if necessary. Air Cap Seal FIG. N Groove Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com...
Page 7
– Install air cap and air cap ring. Spray gun is now re-assembled and ready to use. FIG. R1 FIG. R2 Incorrect Correct FIG. U FIG. S Counterbored Hole Air Cap Seal FIG. V FIG. T Stainless Steel Locating Pin To order parts and supplies: 800.345.1178 >> eastwood.com...
If you have any questions about the use of this product, please contact Eastwood Technical Assistance Service Department: 800.544.5118 >> email: techelp@eastwood.com PDF version of this manual is available online >> eastwood.com/ 15334manual The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA US and Canada: 800.345.1178...