Mitsubishi Electric 800 Series Instruction Manual page 2

Safety instructions
Thank you for choosing this Mitsubishi Electric inverter plug-in option.
This Instruction Manual provides handling information and precautions for use of this product. Incorrect handling might cause an unexpected
fault. Before using this product, read all relevant instruction manuals carefully to ensure proper use.
Please forward this Instruction Manual to the end user.
Do not attempt to install, operate, maintain or inspect this product until you have read this Instruction Manual and appended documents
carefully. Do not use this product until you have a full knowledge of this product mechanism, safety information and instructions. In this
Instruction Manual, the safety instruction levels are classified into "WARNING" and "CAUTION".
WARNING
Incorrect handling may cause hazardous conditions, resulting in death or severe injury.
Incorrect handling may cause hazardous conditions, resulting in medium or slight injury, or may cause only material
CAUTION
damage.
CAUTION
Note that even the
instructions of both levels as they are critical to personnel safety.
 Electric Shock Prevention
WARNING
 Do not remove the front cover or the wiring cover while the power of the inverter is ON, and do not run the inverter with the front cover or the
wiring cover removed, as the exposed high voltage terminals or the charging part of the circuitry can be touched. Doing so may cause an
electric shock.
 Even if power is OFF, do not remove the front cover of the inverter except for wiring or periodic inspection, as the inside of the inverter is
charged. Doing so may cause an electric shock.
 Before wiring or inspection, check that the LED display of the operation panel is OFF. Any person who is involved in wiring or inspection shall
wait for at least 10 minutes after the power supply has been switched OFF and check that there is no residual voltage using a tester or the
like. For some time after the power-OFF, a high voltage remains in the smoothing capacitor, and it is dangerous.
 Any person who is involved in wiring or inspection of this product shall be fully competent to do the work.
 The plug-in option must be installed before wiring. Otherwise you may get an electric shock or be injured.
 Do not touch the plug-in option or handle the cables with wet hands. Doing so may cause an electric shock.
 Do not subject the cables to scratches, excessive stress, heavy loads or pinching. Doing so may cause an electric shock.
2
level may lead to a serious consequence depending on conditions. Be sure to follow the