Mitsubishi Electric 800 Series Instruction Manual page 3

 Injury Prevention
CAUTION
 The voltage applied to each terminal must be as specified in the Instruction Manual. Otherwise an explosion or damage may occur.
 The cables must be connected to the correct terminals. Otherwise an explosion or damage may occur.
 The polarity (+ and -) must be correct. Otherwise an explosion or damage may occur.
 While power is ON or for some time after power OFF, do not touch the inverter as it will be extremely hot. Doing so may cause burns.
 Additional Instructions
The following instructions must be also followed. If the product is handled incorrectly, it may cause unexpected fault, an injury, or an electric
shock.
CAUTION
Transportation and installation
 Do not install or operate the plug-in option if it is damaged or has parts missing.
 Do not stand or rest heavy objects on the product.
 Ensure the mounting orientation of this product is correct.
 Prevent conductive items such as screws and metal fragments, or flammable substances such as oil from entering this product.
 If halogens (including fluorine, chlorine, bromine, and iodine) contained in fumigants for wood packages enter this product, the product may
be damaged. Prevent the entry of fumigant residuals or use an alternative method such as heat disinfection. Note that sterilization or
disinfection of wood packages should be performed before packing the product.
Trial operation
 Before starting operation, confirm or adjust the parameter settings. Failure to do so may cause some machines to make unexpected
motions.
WARNING
Usage
 Do not modify the equipment.
 Do not remove any part which is not instructed in this manual. Doing so may lead to fault or damage of the product.
CAUTION
Usage
 As all parameters return to their initial values after Parameter clear or All parameter clear is performed, the parameters must be set again as
required before the operation is started.
 Static electricity in your body must be discharged before you touch the product.
Maintenance, inspection and parts replacement
 Do not carry out a megger (insulation resistance) test.
Disposal
 The inverter must be treated as industrial waste.
3