Jobs And Multi-Access - Sharp AR-215 Operation Manual

Multi-Access
A misfeed has occurred.
●
A temporary interruption of operation has occurred due to an error during a copy job (for details,
●
refer to "Operation when an error occurs").

Jobs and Multi-Access

Changing jobs
In the case of a walkup job, you can temporarily interrupt a job that is currently being executed and
perform the walkup job. However, this is not possible when the current job is a two-sided copy or
two-sided print job.
Displaying the job status menu
You can check the status of a job from the job status menu. For information on the job status
menu, refer to the operation manuals for each mode.
1
Press the JOB STATUS key.
●
●
Items in the job status menu
FUNCTION REVIEW
This shows selection of two-sided copying, sort copy, and special functions for copy jobs,
and special functions for fax transmission jobs. Information on the function setting status
can be found in the operation manual for the unit and the operation manual for fax mode.
JOB OUTPUT
This shows the status of auto print jobs, the paper size, tray information.
TX/RX JOBS, TX/RX RESERVE, CONFIDENTIAL RX
These items appear when the JOB STATUS key is pressed in fax mode. Information on
fax status messages can be found in the operation manual for fax mode.
MANUAL RECEIVING
When this is selected, faxes can be received manually from modes other than fax mode.
( page 8)
Notes
If the machine does not have the fax feature, "MANUAL RECEIVING" will not appear.
●
If the machine does not have the fax feature, the print job status menu appears when the
●
JOB STATUS key is pressed from print or scan mode.
Conditions in which the job status menu cannot be displayed
The job status menu cannot be displayed when the machine is in the following states.
An error has occurred that requires a service call.
●
A key operator program is being used.
●
5
Downloaded from: http://www.usersmanualguide.com/
The job status menu appears in the display.
The display varies depending on the current mode when the JOB STATUS key is pressed.