System Board; Removing The System Board - Dell XPS 13 Plus 9320 Service Manual

11. Align the screw holes on the display-assembly cable bracket with the screw holes on the system board and tighten the three
captive screws (M1.6x2).
Next steps
1. Install the base cover.
2. Follow the procedure in

System board

Removing the system board

Prerequisites
1. Follow the procedure in
2. Remove the base cover.
3. Remove the M.2 2230 solid-state drive
4. Remove the battery.
5. Remove the fans.
6. Remove the heat sink.
About this task
The following image indicates the connectors and component(s) on your system board.
Figure 1. System-board connectors
1. Wireless card
3. Display-assembly cable connector
5. Left-speaker cable connector
7. Haptic-module cable connector
9. Battery cable connector
11. Right-fan cable connector
13. Power-button and fingerprint-reader cable connector
The following image(s) indicate the location of the system board and provides a visual representation of the removal procedure.
After working inside your
Before working inside your
or M.2 2280 solid-state drive
computer.
computer.
from M.2 slot, whichever applicable.
2. Camera-assembly cable connector
4. Capacitive touch-panel cable connector
6. Left-fan cable connector
8. M.2 solid-state drive slot
10. Keyboard-daughterboard cable connector
12. Right-speaker cable connector
Removing and installing components 33