6. Connect the keyboard cable and close the latch of the keyboard connector.
Next steps
1. Install the
power button with fingerprint
2. Install the
system
board.
NOTE:
The system board can be replaced with the following components attached:
● heat sink
● fans
● solid-state drive
3. Install the battery.
4. Install the
base
cover.
5. Follow the procedure in
Palm-rest assembly
Removing the palm-rest assembly
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
4. Remove the
system
board.
NOTE:
The system board can be removed with the following components attached:
● heat sink
● fans
● solid-state drive
5. Remove the
power button with fingerprint
6. Remove the keyboard.
About this task
The following image(s) indicate the location of the palm-rest assembly and provides a visual representation of the removal
procedure.
44
Removing and installing components
reader.
After working inside your
Before working inside your
reader.
computer.
computer.