Installing The Power Button With Fingerprint Reader - Dell XPS 13 Plus 9320 Service Manual

Installing the power button with fingerprint reader

Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the power button with fingerprint reader and provides a visual representation of
the installation procedure.
Steps
1. Open the display assembly to a 90-degree angle and place the computer on the edge of a flat surface.
2. Thread the power-button cable through the opening on the palm-rest and keyboard assembly.
3. Place the power button with fingerprint reader on the palm-rest and keyboard assembly.
4. Align the screw holes of the power button with the screw holes of the power-button bracket.
5. Replace the four screws (M1.4x2) that secure the power button bracket to the palm-rest and keyboard assembly.
Next steps
1. Install the system board.
NOTE: The system board can be replaced with the following components attached:
● heat sink
● fans
● solid-state drive
2. Install the battery.
3. Install the base cover.
4. Follow the procedure in
40 Removing and installing components
After working inside your computer.