Troubleshooting; Specifications - Stihl BGA 86 Instruction Manual

18 Troubleshooting

18 Troubleshooting
18.1 Troubleshooting the Blower or Battery
Fault LEDs on the
battery
The blower does 1 LED flashing
not start when green.
switched on.
1 LED emits
red light.
3 LEDs flash
red.
3 LEDs light
up red.
4 LEDs fla‐
shing red.
The blower swit‐ 3 LEDs light
ches off while in up red.
operation.
The blower ope‐
rating time is too
short.
STIHL connected
app is unable to
find the battery
with .
18.2 Product Support and Assis‐
tance on Use
Product support and assistance on use are avail‐
able from STIHL servicing dealers.
0458-824-9821-B
Cause
State of charge of the
battery is too low.
The battery is too
warm or too cold.
There is a fault in the
blower.
The blower is too
warm.
There is a fault in the
battery.
There is a break in the
electrical connection
between the blower
and the battery.
The blower or the bat‐
tery is damp.
The blower is too
warm.
There is an electrical
fault.
The battery is not fully
charged.
The battery life has
been exceeded.
®
Bluetooth radio inter‐
face on the battery or
mobile device is deac‐
tivated.
Distance between bat‐
tery and mobile
device is too long.
For contacts and other information, please visit
https://support.stihl.com or www.stihl.com.

19 Specifications

19.1
– Approved batteries:
Remedy
► Recharge the battery fully as described in
the User Manual for the STIHL AL 101,
301, 301-4, 500 chargers.
► Remove the battery.
► Allow the battery to cool down or warm
up.
► Remove the battery.
► Clean electrical contacts in the battery
compartment.
► Insert battery.
► Switch on blower.
► If 3 LEDs continue to flash red: Do not
use the blower and contact your STIHL
dealer for assistance.
► Remove the battery.
► Allow the blower to cool down.
► Remove battery and reinsert it.
► Switch on blower.
► If 4 LEDs continue to flash red: Do not
use the battery; contact a STIHL authori‐
zed dealer.
► Remove the battery.
► Clean electrical contacts in the battery
compartment.
► Insert battery.
► Allow blower or battery to dry.
► Remove the battery.
► Allow the blower to cool down.
► Remove battery and reinsert it.
► Switch on blower.
► Recharge the battery fully as described in
the User Manual for the STIHL AL 101,
301, 301-4, 500 chargers.
► Replace battery.
► Activate Bluetooth
®
battery or mobile device.
► Reduce distance,
► If the battery still cannot be found with
the STIHL connected app: Contact a
STIHL authorized dealer for assistance.
STIHL BGA 86 Blower
English
radio interface on the
19.2.
25