Fujitsu UTY-VBGX Instruction Manual page 153

BACnet Gateway for VRF System
8.7.3 Fujitsu VRF Viewer
Shows specific information about the VRF network communication. This is for Fujitsu internal maintenance purpose
only.
8.7.4 Signals Viewer
Check the current signal values on both: BACnet and VRF network side (connection to the VRF network and/or
BACnet client is required).
The Signals Viewer can be used even though only one system is connected to the gateway, BACnet or Fujitsu AC.
Therefore, it becomes convenient for supervision and testing the system.
In order to force a specific value to a signal, double-click the corresponding BACnet Server Value or Fujitsu VRF
Value cell in the table. Notice that grey cells can't be read or written. Changing its value in this way, will make:
•
The content of the corresponding object will be changed to this value.
•
If the signal is write-enabled, it will trigger a suitable command to Fujitsu AC system.
Copyright© 2021 Fujitsu General Limited - All rights reserved
INSTRUCTION MANUAL r1.4.0 eng
153/159