Fujitsu UTY-VBGX Instruction Manual page 143

BACnet Gateway for VRF System
7.3 LEDs status and push buttons
LED Description
LED_ERR (red) Gateway error state indication. If active, contact your supplier.
LED_PWR (green) Power-on. HW-controlled / non-FW.
LED_1 (green) Ethernet LNK led. Same as Ethernet green led.
LED_2 (yellow) Ethernet ACT led. Same as Ethernet yellow led.
LED_3 (green) Fujitsu bus TX activity.
LED_4 (yellow) Fujitsu bus RX activity.
LED_5 (green) BACnet TX LED.
LED_6 (yellow) BACnet RX LED.
LED_7 (green) Service led of LON port.
LED_8 (green) Device has IP address (after DHCP or manually assigned).
Button Description
PUSH_A Sends I-Am msg on bacnet-ip side.
PUSH_B Service pin of LON port.
Copyright© 2021 Fujitsu General Limited - All rights reserved
INSTRUCTION MANUAL r1.4.0 eng
Button - A
Button - B
LED_PWR (Green)
LED_ERR (Red)
LED_1 (Green)
LED_3 (Green)
LED_5 (Green)
LED_7 (Green)
LED_8 (Green)
LED_2 (Yellow)
LED_4 (Yellow)
LED_6 (Yellow)
143/159