Fujitsu UTY-VBGX Instruction Manual page 149

BACnet Gateway for VRF System
4. Scan Air Units:
Use this function to scan the VRF network automatically to look for the current units connected to the system.
Note: Scan may take from 5 to 6 minutes depending on each installation specs.
8.5 Signals
Check the current available signals according to the units configured on the configuration tab (see section 8.4.3).
1. Signal number: Configuration Tool internal reference.
2. Active: Indicates if the signal is currently active for this configuration. If not, it will not be considered by
the tool when downloading it to the gateway.
Figure 8.9 Units scan on the FGL bus
Figure 8.10 Signals' Viewer
Copyright© 2021 Fujitsu General Limited - All rights reserved
INSTRUCTION MANUAL r1.4.0 eng
149/159