ALLEN & HEATH GPIO Getting Started Manual

Hide thumbs Also See for GPIO:

Download this manual

GPIO

GPIO is a general purpose I/O interface for control integration of an AHM, Avantis

or dLive system and third party hardware. It offers 8 opto-coupled inputs and 8

relay outputs on Phoenix connectors, in addition to two +10V DC outputs.

Up to 8 GPIO modules can be connected to an AHM, Avantis or dLive system

via Cat cable, directly or via a network switch. GPIO functions are programmed

using the AHM System Manager software, dLive Surface / Director software or

Avantis mixer / Director software and can be configured for a number of install

and broadcast applications, including EVAC (alarm / system mute), broadcast

(on air lights, fader start logic) and theatre automation (curtains, lights).

GPIO requires dLive firmware V1.6 or higher.



Application example

GPIO Getting Started Guide

Getting Started Guide

Inputs from third

party switch panel

Projection

Conference

Outputs deliver DC for

indicator LEDs on control

panel, and switch closure for

screen, projector and lighting

controller.

AP11156 Issue 3

Need help?

Do you have a question about the GPIO and is the answer not in the manual?

Page 1 Phoenix connectors, in addition to two +10V DC outputs. Up to 8 GPIO modules can be connected to an AHM, Avantis or dLive system via Cat cable, directly or via a network switch. GPIO functions are programmed...
Page 2  Outputs – 8x relay outputs and 2x 10V DC outputs. All relay outputs are normally open by default. Output 1 can be configured to be normally closed as indicated here: Cut solder link LK11 on the internal PCB. Solder link LK10. Normally Open Normally Closed GPIO Getting Started Guide AP11156 Issue 3...
Page 3 Installation GPIO can be used free standing or up to two units can be installed in a 1U rack space using our optional rack ear kit FULLU-RK19 which can be ordered from your A&H dealer. STP Cat5 or higher cables are required, with a maximum cable length of 100m per connection.
Page 4 Register your product with Allen & Heath online at: http://www.allen-heath.com/support/register-product/ Check the Allen & Heath website for the latest documentation and software updates. ALLEN&HEATH Copyright © 2021 Allen & Heath. All rights reserved. GPIO Getting Started Guide AP11156 Issue 3...