Related Manuals for Bestway 58498E
Summary of Contents for Bestway 58498E
- Page 1 WE SUGGEST NOT TO RETURN THE PRODUCT TO THE STORE QUESTIONS? PROBLEMS? MISSING PARTS? For FAQ, Manuals, Videos Or Spare Parts, Please Visit bestwaycorp.com/support 58498E Hmax 1.5 m OWNER’S MANUAL bestwaycorp.com/support Visit Bestway YouTube channel...
-
Page 2: Safety Instructions
SAND FILTER OWNER’S MANUAL SAFETY INSTRUCTIONS WARNING IMPORTANT SAFETY INSTRUCTIONS When installing and using this electrical equipment, basic safety precautions should always be followed, including the following: READ AND FOLLOW ALL INSTRUCTIONS WARNING TO REDUCE THE RISK OF INJURY - do not permit children to use this product unless they are closely supervised at all times. - Page 3 Please examine and verify all sand filter components are present before use. Notify Bestway at the customer service address listed on this manual for any damaged or missing parts at the time of purchase.
- Page 4 interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. WARNING: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC...
- Page 5 IMPORTANT SAFETY INSTRUCTIONS READ, FOLLOW, AND UNDERSTAND ALL INSTRUCTIONS AND WARNINGS. - Any modification that increases the flow rate of the circulation system shall require re-evaluation of the cover/grate and sump to ensure that the flow rating of the Suction Outlet Fitting Assembly (SOFA) is not exceeded. - Missing, broken, or cracked cover/grates, sumps, mud-frames, or any other SOFA component shall be replaced before bathers are allowed to use the pool.
-
Page 6: Specifications
installation. 7. Before using the product, please check the integrity of the head of the suction fitting. If the product is broken, please do not use it. 8. - All SOFAs shall be installed in accordance with the manufacturer’s installation instructions. - Page 7 PARTS REFERENCE OVERVIEW Before assembling the sand filter, take a few minutes to become familiar with all the sand filter parts. REF.NO SPARE PART NO. P03831 P61138ASS16 P03832 P61209ASS16 P03837 P03838 P61211ASS16 P6581ASS16 P6580ASS16 P03839 P6614ASS16 P6029ASS16 P03830 P61214ASS16 P03841 P03829 P6916ASS16 P6124ASS16...
- Page 8 servicing and winterizing. 3. The sand filter must be vertically fixed on ground or a certain pedestal made of wood or concrete before use to prevent the sand filter from accidentally falling. Fully assembled sand filter will exceed 18 kg. The mounting holes should be 8 mm in diameter and spaced 86 mm apart.
- Page 9 MAX. MIN . CONNECT TO THE POOL...
- Page 10 Garden hose (not included) For Drain, Backwash, Rinse function P6680ASS16...
-
Page 11: Operation
FOR POOL WITH 1.25 IN. (32 MM) VALVE P6916ASS16 P61318ASS16 P61322ASS16/P6680ASS16 STOP Before switching on, please read the manual carefully. GFCI TEST RESET RESET RESET TEST TEST TEST OPERATION CONTROL VALVE OVERVIEW WARNING: To prevent equipment damage and possible injury, always switch off sand filter before changing the Control Valve function. - Page 12 Filter: Closed: This function is used to filter pool water This function stops water flowing and should be positioned here 99% of the time. between the sand filter and the pool. Water is pumped through the sand filter, where it is cleaned and returned to the pool.
- Page 13 NOTE: • Be sure all provisions for wastewater disposal meet applicable local, state or national codes. Do not discharge water where it will cause flooding or damage. • When the Control Valve is set to the Backwash, Rinse, or Drain position, water will discharge from Port D on the Control Valve.
- Page 14 1. Now the sand filter is ready for use. Set the Control Valve to the Filter function. NOTE: To prevent the risk of electrical shock dry any excess water from yourself and the sand filter. 2. Switch on the sand filter to run it. NOTE: The sand filter has now started its filtering cycle.
-
Page 15: Cleaning The Strainer
CLEANING THE STRAINER 1. Switch off the sand filter and set the Control Valve to the Closed function. 2. Close the connection valves. 3. Remove the Strainer Cover by unscrewing 4. Take out the Strainer, remove any debris. 5. Put the Strainer back into position. Ensure the hole in the strainer is aligned. -
Page 16: Troubleshooting
Distributed in Australia & New Zealand by Bestway Australia Pty Ltd, Unit 2/98-104 Carnarvon St Silverwater, NSW 2128, Australia Tel: Australia: (+61) 29 0371 388; New Zealand: 0800 142 101 Distributed in United Kingdom by Bestway Corp UK Ltd. 8 Wentworth Road, Heathfield Industrial Estate, Newton Abbot, Devon, TQ12 6TL Exported by/Exporté par/Exportado por/Exportiert von/Esportato da Bestway (Hong Kong) International Ltd./Bestway Enterprise Company Limited...
Need help?
Do you have a question about the 58498E and is the answer not in the manual?
Questions and answers
2023 bestway sand filter 58498e need a hose gasket. book says its a #12