Garnet SeeLevel 710-JS Manual page 8

PREPARE SENDER FOR INSTALLATION
❶
Clean the tank
Clean area throughly where the sender will be
mounted making sure there is no dust, grease
and oil.
Acetone or rubbing alcohol will remove sticky
residue.
SeeLeveL Sender Installation Manual 710-JS / 710-ES / 710-SS
❷ Temporarily tape sender on tank
CAUTION: DO NOT SKIP THE FOLLOWING STEPS. Removing the sender
W
from the tank after the sender has been permanently installed will cause damage
to the sender that is NOT covered under warranty.
Once the sender is cut and programmed, temporarily tape the sender
to the tank wall. Place a piece along the length of both sides of the
sender and perform a test to verify operation.
W
CAUTION: Route wires to the right, away
from the senders. The wires indicate the top
of the sender.
Use a non aggressive
tape like painters tape
or masking tape.
Page 8