Table of Contents
Advertisement
MOUNTING THE SENDER
❺
Permanently adhere sender to the tank
Once proper operation has been confirmed,
the sender will be ready to permanently
stick to the tank wall.
Remove one side of the tape.
Fold the sender over so it is still attached
with one side of the tape.
Slowly peel the backing paper off the
adhesive.
W
CAUTION: Be careful not to bend the senders excessively or you
could damage the circuits. You only have one shot at this. If you try
to peel it off the tank once it is stuck the sender may be damaged
by the sharp bending. Removing the sender after it's been adhered
voids the warranty.
Carefully fold the sender back and press the
sender down to the tank so that all of the
adhesive is contacting the tank wall. Make
sure there are no air gaps between the sender
and the tank. Remove the other side of the
temporary tape.
SeeLeveL Sender Installation Manual 710-JS / 710-ES / 710-SS
❻
Secure the wires
Secure the wires with duct tape, tie wraps, or
something similar so that the wires do not rattle or
press against the sender, this may result in sender
damage or wires breaking over time.
❼
Apply undercoating to the senders
On installations where the holding tank is exposed
to under chassis road spray and flying rocks etc. We
recommend the use of a rubberized undercoating.
Recommended brands:
3M 03584 Professional Grade Rubberized Undercoating
Gravel Guard Rocker Guard Coating By Dominion Sure Seal
Page 11
Advertisement
Table of Contents
