Advertisement
2. Click the Abort Load or Stop Download toolbar button to verify that the download process is
NOT active.
3. Select the GEN2 Printers Only! check box.
4. Connect the printer using one of the following methods:
•
RS232. Connect the printer to the PC using the FutureLogic, Inc. Evaluation
Cable (Part Number 150-00044) or other approved cabling.
•
Netplex. Connect using the Convert Box and Power Supply.
5. Power up the printer.
6. (Optional) Set up your preferences if using the Download Utility for the first time.
a. Click the Preferences toolbar button.
The Auto Download Preferences dialog displays.
Toolbar
Buttons
b. Select the communications port to which the printer is connected in the Select Comm
Ports for Auto Mode area.
c. Click the Apply button.
d. Click the Select Firmware button to set up the firmware.
Note: The firmware file (.VFX) must be located in the same folder as the Download Utility.
e. Select the firmware file and click the Open button.
The Auto Download Preferences dialog updates to display the version number of the
selected firmware file.
© 2004 – 2005 FutureLogic, Incorporated. All Rights Reserved.
Figure 1-4
Download Utility Toolbar
Figure 1-5
Auto Download Preferences Dialog
Firmware Download Utility Instructions
PUBN Page 3 of 10 05/04/2005
PUBN-000027 REV.B
Select Comm
Ports For Auto
Mode Area
Advertisement
