Kogan KA32LICEMKA User Manual page 8

3. Press the ON/OFF button on the control panel to turn on the ice cube maker and
begin the ice-making cycle.
You may select the size of the ice cubes by pressing the select button on the control
panel. There are three sizes (small, medium, large). These are reflected by the ice
cube size indicator on the LCD display.
The ice-making cycle will take between 6–13 minutes. This variability depends on the
selected ice cube size and ambient temperature.
Note:
If the room temperature is lower than 15°C, it is recommended to select the
small or medium ice cube sizes to avoid the ice cubes sticking together.
4. Open the cover and use the ice scoop to take out the ice cubes.
Note:
Change the water in the reservoir every 24 hours to ensure proper hygiene. If
the unit will not be in use, drain all water out.
No water indicator
When making ice, check the water level periodically. If the water pump is unable to pump
water, the ice maker will stop automatically. The no water indicator ' ' will start flashing on
the control panel.
1. Refill the water up to the 'MAX' line, then wait for at least three minutes to allow the
refrigerant liquid to settle.
2. Press the ON/OFF button to restart the ice cube maker and resume use.
Ice full indicator
The ice cube maker will automatically stop operating when the ice bucket is full. The ice full
indicator ' ' will illuminate on the control panel.
• Using the ice scoop, remove ice from the appliance.
MEDIUM
SMALL
LARGE