Advertisement
Quick Links
Advertisement
Related Manuals for EasyRobotics EASYDESK
Summary of Contents for EasyRobotics EASYDESK
- Page 1 EASYDESK USER MANUAL...
-
Page 2: Table Of Contents
Dimensions .................... 10 Information contained herein is the property of EasyRobotics ApS and shall not be reproduced in whole or in part without prior written approval of EasyRobotics ApS. The information herein is subject to change without notice and should not be construed as a commitment by EasyRobotics ApS. -
Page 3: Introduction/Intended Use
The intension of this manual is to give a guideline of mounting a cobot at the EasyDesk and this is not valid as a CE marking of the robot cell. A risk assessment most be full filled after the full installation is concluded. Including the robot, gripper and other equipment and installations at the workspace. -
Page 4: Installation
3 Installation The installation of the EasyDesk must be carried out only by trained, skilled personnel with the relevant profession. It is crucial to the safety and function of the machine, that it is properly aligned and securely anchored. 3.1 Fix to floor Securely anchor the EasyDesk to the floor with floor-suitable anchor bolts. - Page 5 3.2 Relocate bracket for the teach pendant on the EasyDesk The T-Pad bracket can be mounted in two directions: 1. Parallel 2. Perpendicular Relocate the T-Pad bracket so it fits the used brand. Revision: 2021-11 EasyRobotics ApS ProFeeder X, X-XL, Compact & Compact-XL User-Manual...
- Page 6 Release the locking pin, drag out the drawer and put the locking pin in the slot to fixate the drawer. Place the controller on the drawer and the cables in the energy chain. Release the locking pin and place the drawer back into the EasyDesk. Revision: 2021-11 EasyRobotics ApS ProFeeder X, X-XL, Compact &...
- Page 7 10mm. This will allow the robot console to slide into position due to the two keyhole-shaped holes. Fasten all 8x M8x20. Revision: 2021-11 EasyRobotics ApS ProFeeder X, X-XL, Compact & Compact-XL User-Manual Page 6 of 26...
- Page 8 Mount the shroud and ensure that the cable goes into the cable hole. Revision: 2021-11 EasyRobotics ApS ProFeeder X, X-XL, Compact & Compact-XL User-Manual Page 7 of 26...
-
Page 9: Adjustments
4.1 Adjusting the feet Loosen the lock nut, adjust the foot by turning, retighten the lock nut. The feet should be adjusted so: The EasyDesk stands stable without rocking, use a bubble level. Revision: 2021-11 EasyRobotics ApS ProFeeder X, X-XL, Compact & Compact-XL User-Manual... -
Page 10: Transport
5 Transport 5.1 Fixation for transport Ensure that the locking pin is insert during transport to prevent any undesirable extension. Revision: 2021-11 EasyRobotics ApS ProFeeder X, X-XL, Compact & Compact-XL User-Manual Page 9 of 26... -
Page 11: Dimensions
6 Dimensions Revision: 2021-11 EasyRobotics ApS ProFeeder X, X-XL, Compact & Compact-XL User-Manual Page 10 of 26...
Need help?
Do you have a question about the EASYDESK and is the answer not in the manual?
Questions and answers