Aisg Control Cable; Figure 4-6 Appearance Of The External Monitoring Cable - Zte ZXSDR R8882 Hardware Description

External View
Figure 4-6
with an 8-pin round plug. End B needs to be mounted with an appropriate connector on
site according to the connector type of the external device to be connected. The cable
length is 1.2 m.

Figure 4-6 Appearance of the External Monitoring Cable

Signal Definition
Pin
PIN1
PIN2
PIN3
PIN4
PIN5
PIN6
PIN7
PIN8
Connection
l
End A is connected to the MON interface on the ZXSDR R8882 chassis.
l
End B is connected to an external monitoring device or a dry contact device.

4.7 AISG Control Cable

Function
The AISG control cable is used to send
connected to the ZXSDR R8882.
External View
An 8-pin aviation plug in compliance with IEC 60130-9-ED is mounted on both ends of the
AISG control cable, as shown in
SJ-20111021104623-003|2012–01–30 (R1.1)
shows the external view of the external monitoring cable. End A is mounted
Name
Dry_Node_In1+
Dry_Node_In1-
Dry_Node_In2+
Dry_Node_In2-
RS485TX+
RS485TX-
RS485RX+
RS485RX-
Definition
Dry contact input, positive
Dry contact input, negative
Dry contact input, positive
Dry contact input, negative
Full-duplex RS422/RS485TX+ (differential mode)
Full-duplex RS422/RS485TX- (differential mode)
Full-duplex RS422/RS485RX+ (differential mode) or
half-duplex RS485A
Full-duplex RS422/RS485RX- (differential mode) or
half-duplex RS485B
AISG control signals to an
Figure 4-7.
4-5
Chapter 4 External Cables
RET antenna that is
ZTE Proprietary and Confidential