Advertisement
Carefree of Colorado
O
PERATION
S
ETUP
Tension Handle
Pin
Retaining
Strap
Ground Support
1. Extend the awning completely according to the instructions with the awning.
2. For removable arms:
•
Holding the arm at approximately 45° firmly press the rubber bushing (inside the channel) into the
large slot of the support bracket.
•
If the arm is equipped with the ground support, release the retaining strap and allow the support to
rotate out of the arm.
•
Loosen the locking knob on the arm.
3. For permanent mount arms:
•
Loosen the locking knob on the arm and slide the pin up and out of the storage bracket.
•
If the arm is equipped with the ground support, release the retaining strap and allow the support to
rotate out of the arm.
4. Open the tension handle.
5. Rotate the arm up, slide the channel out and insert the pin into the hole in the awning roll bar. Tighten
the arm locking knob.
6. Close the tension handle. If the handle does not close, loosen the locking knob and adjust the length of
the rafter as required.
Locking Knob
Locking Knob
Carport Foot
Figure 6. Setting Up the Rafter VI.
Rafter VI
o
45
Removable
Installation
Locking Knob
Tension Handle
Storage Bracket
Permanent
Installation
Rafter6002
Advertisement
