Table of Contents
Advertisement
Cable Connections
Make the following connections on the Thecus N299 and then power up the unit:
1. Connect an Ethernet cable from your network to the WAN port on the
back panel of the N299.
2. Connect the provided power cord into the universal power socket on the
back panel. Plug the other end of the cord into a surge protected socket.
3. Press the power button on the front panel to power on the N299.
4. Make sure system is running properly by checking all front panel LEDs for
any error indications.
Installation Wizard
The handy Thecus Setup Wizard makes configuring N299 a snap. To configure the
N299 using the Setup Wizard, perform the following steps:
1. Insert the installation CD into your CD-ROM drive (the host PC must be
connected to the network).
2. The Setup Wizard should launch automatically. If not, please browse your
CD-ROM drive and double click on Setup.exe.
NOTE
3. Complete the Setup Wizard
a. Device Discovery
The Setup Wizard will start and automatically detect all Thecus Storage
devices on your network.
For MAC OS X users, double click on Thecus Setup Wizard 1.1.6.dmg
13
Advertisement
Table of Contents
