Table of Contents
Advertisement
Network Management
Use the Network menu to make
network configuration settings as
well as service support settings.
WAN Configuration
From the Network menu, choose
WAN, and the WAN Configuration
screen appears. This screen displays
the network parameters of the WAN
connection. You may change any of
these items and press Apply to
confirm your settings. You can see a
description of each item in the
following table:
WAN Configuration
Item
Host name
Domain name
MAC Address
Jumbo Frame Support
Connection Type
User Name
Password
IP
Netmask
DNS Server
IP Sharing Mode
PPPoE Connect
NOTE
WARNING
Description
Host name that identifies the N299 on the network.
Specifies the domain name of the N299.
Display the WAN port MAC address.
Enable or disable Jumbo Frame Support of the WAN interface on
your N299.
The WAN IP can be set to a Static IP, Dynamic IP, or PPPoE.
Static: Administrator has to enter IP, Netmask, Gateway, DNS
Server fields.
Dynamic: If there is already a DHCP server on your network,
you can let the DHCP server assign an IP address to your N299.
NOTE: If this is set to Dynamic, but a DHCP server is not
detected on the WAN network, the IP address of the N299 will
reset to the default setting of 192.168.1.100.
PPPoE: The N299 can also support a direct connection to an
ASDL modem through PPPoE. Once selected, you will need to
enter a User Name and Password.
Enter your user name for PPPoE connection. (PPPoE only)
Enter your password for PPPoE connection. (PPPoE only)
IP address of the WAN interface.
Network mask, which is generally: 255.255.255.0
Domain Name Service (DNS) server IP address.
When enabled, traffic on the LAN will be directed to the WAN.
Default is Disabled.
Connect or disconnect from a PPPoE connection. (PPPoE only)
• Only use Jumbo Frame settings when operating in a Gigabit environment where
all other clients have Jumbo Frame Setting enabled.
• Enabling DHCP automatically turns on UPnP — See the Service Support
Screen.
• If you are only using the WAN port, we suggest that you disable IP Sharing
Mode. This will result in higher throughput.
• A correct DNS setting is vital to networks services, such as SMTP and NTP.
Most Fast Ethernet (10/100) Switches/Routers do not support Jumbo Frame and
you will not be able to connect to your N299 after Jumbo Frame is turned on. If this
happens, turn off the N299. Then, power on the N299 and immediately press and
hold the Reset button on the rear of the unit for 15 seconds. This will reset your
network settings, password, and turn off Jumbo Frame Support.
29
Advertisement
Table of Contents
