Disassembling The Actuator - Emerson Damcos KC 65 Quick Installation Manual

Disassembling the Actuator

February 2020
Disassembling the Actuator
Caution!
Disassembling the Actuator
1. Place the actuator unit on a clean, worktable.
Caution!
Models without DPI:
upwards in order to avoid the yoke in the control block from dropping into the piston tube.
2. Loosen and remove the
bleed valve by use of a
fork wrench.
3. Dismount the visual indi-
cator by use of a fork
wrench.
4. DPI models only!
mount the DPI socket by
use of a fork wrench.
Make sure the work table is cleaned and without dirt and impurities in order avoid the
risk of getting dirt into the actuator, as this may damage the internal parts when reas-
sembled and put in operation.
Do not use any tools on the smooth/round surface of the actuator spindle.
In general, only use tools on wrench-grip surfaces and holes prepared for tools.
Keep the actuator placed on the side with the visual indicator pointing
Dis-
Quick Installation Guide
QIG 8000-81-003 Ed 01
31