Cleaning And Care; Delivery Set - Vitek VT-1332 Manual Instruction

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Unpack the unit and remove any
stickers that can prevent unit oper-
ation.
Check the unit for damages, do not
use it in case of damages.
Before switching the unit on, make
sure that the voltage of the mains
corresponds to the unit operating
voltage.
USAGE
To get the best results, wash your hair
with shampoo, wipe it with a dry towel,
dry with a hairdryer and comb your hair.
After that you can start styling your hair.
Divide the hair into locks 4-5 cm wide.
Insert the power plug into the mains
socket.
Set the ON/OFF button (2) to the
«I» position, the power indicator (3)
will light up.
Put the unit on the safety stand (7)
on a flat heat-resistant surface and
let it heat up.
Take a hair lock with the free hand.
Press the clamp handle (4), place
the end of the lock on the operat-
ing surface (5) and move the clamp
down. Wind the lock around the
operating surface.
Wait for a while, then press the clamp
handle (4) and release the hair lock.
Repeat this procedure on the rest
of your hair.
Note:
Do not touch the operating surface
during the unit operation.
During the first operation some
foreign smell and a small amount
of smoke from the operating sur-
face is possible, this is normal.
332.indd 5
During breaks in operation, place
the unit on a flat heat-resistant sur-
face.
Do not comb your hair right after
styling, let it cool off. Divide big
locks into smaller ones carefully to
make the hairstyle look natural.
After you finish curling, switch the
unit off by setting the ON/OFF but-
ton (2) to the «0» position, the indi-
cator (3) will go out.
Unplug the unit.
Put the unit on the safety stand (7)
and let it cool down completely.

CLEANING AND CARE

Before cleaning unplug the unit and
let it cool down completely.
Do not immerse the unit, the power
cord and the power plug into water
or any other liquids.
Do not use detergents, abrasives,
and any solvents to clean the unit.
Clean the unit body with a soft,
slightly damp cloth and then wipe
it dry.
STORAGE
Let the unit cool down completely
and clean it before taking away for
storage.
Do not wind the power cord around
the unit body as this can damage
the cord.
Keep the unit in a dry cool place out
of reach of children and disabled
persons.

DELIVERY SET

Curling tongs – 1 pc.
Instruction manual – 1 pc.
5
ENGLISH
9/16/20 6:16

Advertisement

Table of Contents
loading

Table of Contents