Cleaning And Care - Vitek MW-2410 BK Manual Instruction

USAGE
To get the best results, wash your hair with shampoo,
wipe it with a dry towel, dry with a hairdryer and comb
your hair. After that you can start styling your hair.
– Divide the hair into locks 4-5 cm wide.
– Put the unit on the safety stand (3) on a flat heat-
– Insert the plug into the mains socket.
– Switch the unit on by setting the power switch (6) to
– Wait for some time required for the operation surface
– Take a hair lock with the free hand.
– Press the clamp handle (4), place the end of the lock
– Wait for a while, then press the clamp handle (4) and
– Repeat this procedure on the rest of your hair.
Notes:
– during the first operation some foreign smell and a
– do not touch the operating surface (2) during the unit
– during breaks in operation, place the unit on the safe-
– do not comb the hair right after curling it, let it cool
– After the unit operation, switch the unit off by set-
– Put the unit on the safety stand (3) on a flat heat-

CLEANING AND CARE

– Before cleaning unplug the unit and let it cool down
IM MW-2410.indd 13
resistant surface.
the position «ON», the light indicator (5) will light up.
(2) heating.
on the operating surface (2) and move the clamp (4)
down. Holding onto the protecting tip (1) and handle
(7), wind the lock around the operating surface (2).
release the hair lock.
small amount of smoke from the heating element is
possible, it is normal.
operation, hold the unit by the protecting tip (1) with
one hand and by the handle with the other (7).
ty stand (3) on a flat heat-resistant surface.
down, divide big locks into smaller ones carefully to
make the hairstyle look natural.
ting the power switch (6) to the "OFF" position and
unplug it.
resistant surface and let it cool down completely.
completely.
ENGLISH
13
12/20/17 12:54 PM