Advertisement
安全技巧
装配时为避免挤压和切割受伤, 必须戴上手套.
本产品只允许作为洗浴, 卫生和洁身之用.
冷热水管间过大的压力差必须予以平衡.
安装提示
• 安装前必须检查产品是否受到运输损害. 安装后
将不认可运输损害或表面损伤.
• 管道和阀门必须根据通用标准进行安装, 冲洗和
检查.
• 请遵守当地国家现行的安装规定.
• 只能按规定使用溢流阀. 禁止将半露柱及其他部
件固定到溢流阀上.
技术参数
工作压强:
推荐工作压强:
测试压强:
热水温度:
热力消毒:
该产品专为饮用水设计!
符号说明
请勿使用含有乙酸的硅胶!
调节 (参见第页 6)
热水温度调节. 如果使用即热式喷头, 则不建议安
装热水阀门.
大小 (参见第页 7)
流量示意图 (参见第页 7)
备用零件 (参见第页 11)
清洗 (参见第页 8)
操作 (参见第页 10)
汉斯格雅建议, 清晨或在水流长时间停滞后, 前半
升水不作饮用水使用.
(参见第页 3)
2
中文
最大 1 MPa
0,1 - 0,5 MPa
(1 MPa = 10 bar = 147 PSI)
最大 60°C
70°C / 4 分钟
安装
Safety Notes
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The product may only be used for bathing, hygienic
and body cleaning purposes.
The hot and cold supplies must be of equal pressures.
Installation Instructions
• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.
• The drain valve must only be used as intended. It is
not allowed to attach other objects to the drain valve,
for example a semi-pedestal.
1,6 MPa
Technical Data
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Thermal disinfection:
The product is exclusively designed for drinking water!
Symbol description
Do not use silicone containing acetic acid!
Adjustment (see page 6)
To adjust the hot water limiter. Using a hot water limiter in
combination with a continuous flow water heater is not
recommended.
Dimensions (see page 7)
Flow diagram (see page 7)
Spare parts (see page 11)
Cleaning (see page 8)
Operation (see page 10)
Hansgrohe recommends not to use as drinking water the
first half liter of water drawn in the morning or after a
prolonged period of non-use.
English
(1 MPa = 10 bar = 147 PSI)
Assembly
(see page 3)
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
max. 60°C
70°C / 4 min
Advertisement
