Thrane&Thrane SAILOR 900 VSAT Quick Manual

Hide thumbs Also See for SAILOR 900 VSAT:

QUICK GUIDE

SAILOR 900 VSAT

Introduction

The SAILOR 900 VSAT system has been

configured during installation with all needed

satellite and modem profiles. After startup it

uses the last selected satellite profile.

To change to another satellite (or modem pro-

file), or change an antenna parameter, connect

a PC to the Antenna Control Unit (ACU) and

enter the built-in web interface.

1. Switch on the SAILOR 900 VSAT at the power

switch of the ACU.

2. Connect a PC to LAN port 3 (Rack version:

Front LAN connector) of the ACU, use a

straight Ethernet cable.

3. Enter the address http://192.168.0.1 (default)

in your Internet browser. The built-in web

interface opens

directly with the

DASHBOARD.

4. Click SETTINGS and

activate the new

satellite profile.

For detailed information see the SAILOR 900

VSAT Installation & user manual.

All manuals and user guides at all-guides.com

Table of Contents

Do you have a question about the SAILOR 900 VSAT and is the answer not in the manual?

Page 1 PC to the Antenna Control Unit (ACU) and enter the built-in web interface. Setup and configuration 1. Switch on the SAILOR 900 VSAT at the power switch of the ACU. 2. Connect a PC to LAN port 3 (Rack version: Front LAN connector) of the ACU, use a straight Ethernet cable.
Page 2 All manuals and user guides at all-guides.com SAILOR 900 VSAT Viewing system parameters Navigation ANT-1 1. Switch on the SAILOR 900 VSAT at ANTENNA STATE POINTING ELEVATION POLARIZATION the power switch of the ACU. AZIMUTH MAIN 2. Use the arrow keys on the keypad...