Table of Contents
Advertisement
18. Test operation of guard by pulling it back.
Guard should spring back over cutterhead
and stop against fence.
— If guard does not snap back, or snaps
back slowly, remove guard and repeat
Steps 16–18.
19. Install belt guard with
" flat washer (see Figure 25).
and
⁄
5
16
20. Install dust port, as shown in Figure 25, using
(4) pre-installed flange screws.
Figure 25. Belt guard and dust port installed.
21. G0814 Only: Assemble knife-setting gauge,
as shown in Figure 26.
Figure 26. Knife-setting gauge assembled.
-24-
⁄
"-18 x 2
⁄
" hex bolt
5
1
16
2
x 4
Dust
Port
Dust Collection
This machine creates a lot of wood chips/
dust during operation. Breathing airborne
dust on a regular basis can result in perma-
nent respiratory illness. Reduce your risk
by wearing a respirator and capturing the
dust with a dust-collection system.
Recommended CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
To connect dust collection hose:
1.
Fit 4" dust hose over dust port, as shown in
Figure 27, and secure with a hose clamp.
Figure 27. Dust hose attached to dust port.
2.
Tug hose to make sure it does not come off.
Note: A tight fit is necessary for proper
performance.
Model G0814/G0814X (Mfd. Since 04/22)
Advertisement
Table of Contents
