Part 6:Troubleshooting - zika MIG200 Operation Manual

Remark: 1. ceramic nozzel, 2 .tungsten collet, 3. tungsten collet body, 4 .short back cap, 5. long back cap.
The above structure is a wearing part, please keep it in stock.
Note：
1) Please connect according to the picture, otherwise it cannot be welded
2) This machine is not a professional high-frequency arc starting argon arc welding machine, it is only a LIFT
TIG contact arc starting or friction starting.
3) Need to use TIG, wp17v torch, this torch is not included, you need to buy it yourself
4) Support welding material, carbon steel, stainless steel, alloy steel, aluminum can not be welded.
5) This welding mode requires the use of tungsten needles, which need to be purchased separately, and the
size of the tungsten needle must match the collet and collet body of the welding gun, otherwise it cannot be
installed
6) In this mode, argon welding must be used.
possible problems
1) There is no response when starting up, please check the plug connection.
2) There is no response when booting up, please open the cover and check whether the internal connection
wires are loose.
3) During the welding process, if the time exceeds 3 minutes, over-current protection may occur. You need to
stop working for a few minutes, let the machine cool for a period of time, and automatically recover. If the air
cools for more than 10 minutes, the machine does not automatically recover, please shut down and restart.
4) If you have any questions, please contact us .
5)Lift tig is different from professional high-frequency tig. Lift tig needs to be welded after contact with arcing.
High-frequency tig does not require contact with arcing. Lift tig is not suitable for spot welding.

Part 6:Troubleshooting

PROBLEMS
(SYMPTOMS)
OUTPUT PROBLEMS
Observe all Safety Guidelines detailed throughout this manual
POSSIBLE
CAUSE
17
Version Number: MIG200-20210914A1