zika MIG200 Operation Manual page 14

keep inventory. 19. The guide wire tube, it is best to equip a spare part because it may damage the
accessories.
Remarks: For gas welding Solid carbon steel wires, please use copper nozzles.
Remarks: For gasless welding flux-cored wires, please use porcelain nozzles.
Note:
1) Please strictly follow the picture instructions to connect, otherwise it will not be possible to solder.
Welding wire supports 0.8mm, 1.0mm.
2) The machine can install 5kg(11lb) and 1kg(2.2lb) wire reels.
3) The machine comes with a 1kg(2.2lb) flux-cored welding wire. Solid welding wire needs to be
purchased separately.
4) Support welding material, carbon steel, stainless steel, If you use a spool gun, aluminum can be
welded.
5) The diameter of the welding wire, the groove of the wire feed wheel and the aperture of the contact tip
must match.
6) The pressure roller of the wire feeding structure should not be too tight or too loose, which will cause
the
wire feeding to be unstable.
7) The installation of the wire feeding reel should not be too loose or too tight, which will cause the
welding
wire of the wire reel to spring off and the wire feeding is too slow.
Possible problems
1) There is no response when turning on the power, please check the plug connection.
14
Version Number: MIG200-20210914A1