Table 28: Port Settings - Juniper EX3300 Series Complete Hardware Manual

Table 28: Port Settings

Port Settings
Bits per second
Data bits
Parity
Stop bits
Flow control
Copyright © 2011, Juniper Networks, Inc.
NOTE: The following procedure uses Hayes-compatible-modem commands
to configure the modem. If your modem is not Hayes-compatible, see the
documentation for your modem for the equivalent modem commands.
To configure the modem:
Connect the modem to the desktop or notebook computer.
1.
Power on the modem.
2.
From the computer, start your asynchronous terminal emulation application (such
3.
as Microsoft Windows HyperTerminal) and select the COM port to which the modem
is connected (for example, COM1).
Configure the port settings shown in
4.
In the HyperTerminal window, type
5.
The modem sends an OK response to verify that it can communicate successfully
with the COM port on your desktop or notebook computer.
To configure the modem to answer a call on the first ring, type
6.
Press Enter.
To configure the modem to accept modem-control DTR signals, type
7.
prompt. Press Enter.
To disable flow control on the modem, type
8.
To set the fixed serial port speed on the modem, type
9.
Enter.
NOTE: You must set the serial port to the fixed speed so that the modem
will not adjust the serial port speed to the negotiated line speed.
To save the new modem settings, type
10.
Chapter 11: Connecting the Switch
Table 28 on page 101.
Value
115200
8
None
1
None
at . Press Enter.
at the prompt. Press Enter.
at&k0
at the prompt. Press
at&b1
at&w0 at the prompt. Press Enter.
at the prompt.
ats0=1
at the
at&d1
101