Download Print this page
Seneca Z-KEY Installation Manual

Seneca Z-KEY Installation Manual

Hide thumbs Also See for Z-KEY:

Advertisement

Quick Links

PRELIMINARY WARNINGS
The word WARNING preceded by the symbol
The word ATTENTION preceded by the symbol
instrument or the connected equipment. The warranty shall become null and void in the event of improper use or
tampering with the module or devices supplied by the manufacturer as necessary for its correct operation, and if
the instructions contained in this manual are not followed.
WARNING: The full content of this manual must be read before any operation. The module must only be used by
qualified electricians. Specific documentation is available via QR-CODE shown on page 1.
Electrical and electronic waste disposal (applicable in the European Union and other countries with recycling).
The symbol on the product or its packaging shows the product must be surrendered to a collection centre
authorized to recycle electrical and electronic waste.
SENECA s.r.l.; Via Austria, 26 – 35127 – PADOVA – ITALY; Tel. +39.049.8705359 - Fax +39.049.8706287
CONTACT INFORMATION
Technical support
This document is the property of SENECA srl. Copies and reproduction are prohibited unless authorised.
The content of this document corresponds to the described products and technologies.
Stated data may be modified or supplemented for technical and/or sales purposes.
MI00580-1-EN
INSTALLATION MANUAL
The module must be repaired and damaged parts replaced by the Manufacturer. The product is sensitive to
electrostatic discharges. Take appropriate measures during any operation.
DOCUMENTATION
Z-KEY
support@seneca.it
INSTALLATION MANUAL
Z-KEY
Z-KEY-P
indicates conditions or actions that put the user's safety at risk.
indicates conditions or actions that might damage the
Product information
DOCUMENTATION
Z-KEY-P
sales@seneca.it
1/4

Advertisement

loading
Need help?

Need help?

Do you have a question about the Z-KEY and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Seneca Z-KEY

  • Page 1 The symbol on the product or its packaging shows the product must be surrendered to a collection centre authorized to recycle electrical and electronic waste. DOCUMENTATION DOCUMENTATION Z-KEY Z-KEY-P SENECA s.r.l.; Via Austria, 26 – 35127 – PADOVA – ITALY; Tel. +39.049.8705359 - Fax +39.049.8706287 CONTACT INFORMATION Technical support support@seneca.it Product information sales@seneca.it This document is the property of SENECA srl.
  • Page 2 Dimensions: 17.5 x 102.5 x 111 mm, Weight: 100 g; Enclosure: PA6, black SIGNALS VIA LED ON FRONT PANEL STATUS LED meaning The device is powered correctly Flashing Profinet communication active Z-KEY-P version only No Profinet communication Flashing Data transmission on port #1 RS485 Flashing Data receipt on port #1 RS485 Flashing...
  • Page 3 To reset the device to factory settings both SW1 DIP switches must be set to ON To force the device’s IP address to the standard value of SENECA Ethernet products: 192.168.90.101 Reserved RS232/RS485 SETTING: RS232 or RS485 configuration on terminals 10-11-12 (serial port 2)
  • Page 4 The device is normally in Profinet mode; in Profinet mode the device can be configured only through the Easy Setup 2 software. In order to access the internal webserver it is necessary to put the device in Webserver mode using the Easy Setup 2 or Seneca Device Discovery software.

This manual is also suitable for:

Z-key-p