Seneca Z-KEY-MBUS Installation Manual

Seneca Z-KEY-MBUS Installation Manual

Advertisement

Quick Links

PRELIMINARY WARNINGS
The word WARNING preceded by the symbol
The word ATTENTION preceded by the symbol
instrument or the connected equipment. The warranty shall become null and void in the event of improper use or
tampering with the module or devices supplied by the manufacturer as necessary for its correct operation, and if
the instructions contained in this manual are not followed.
WARNING: The full content of this manual must be read before any operation. The module must only be used by
qualified electricians. Specific documentation is available via QR-CODE shown on page 1.
Electrical and electronic waste disposal (applicable in the European Union and other countries with recycling).
The symbol on the product or its packaging shows the product must be surrendered to a collection centre
authorized to recycle electrical and electronic waste.
SENECA s.r.l.; Via Austria, 26 – 35127 – PADOVA – ITALY; Tel. +39.049.8705359 - Fax +39.049.8706287
CONTACT INFORMATION
Technical support
This document is the property of SENECA srl. Copies and reproduction are prohibited unless authorised.
The content of this document corresponds to the described products and technologies.
Stated data may be modified or supplemented for technical and/or sales purposes.
MI00589-1-EN
INSTALLATION MANUAL
Z-KEY-MBUS
Z-KEY-MBUS-P
The module must be repaired and damaged parts replaced by the Manufacturer. The product is sensitive to
electrostatic discharges. Take appropriate measures during any operation.
support@seneca.it
INSTALLATION MANUAL
indicates conditions or actions that put the user's safety at risk.
indicates conditions or actions that might damage the
DOCUMENTATION
Product information
sales@seneca.it
1/4

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Z-KEY-MBUS and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Seneca Z-KEY-MBUS

  • Page 1 The symbol on the product or its packaging shows the product must be surrendered to a collection centre authorized to recycle electrical and electronic waste. DOCUMENTATION SENECA s.r.l.; Via Austria, 26 – 35127 – PADOVA – ITALY; Tel. +39.049.8705359 - Fax +39.049.8706287 CONTACT INFORMATION Technical support support@seneca.it...
  • Page 2 Data transmission on port #2 RS485/RS232 Flashing Data reception on port #2 RS485/RS232 ETH ACT Green Flashing Packet transmission on Ethernet port ETH LNK Yellow Ethernet connection present TECHNICAL SPECIFICATIONS CERTIFICATIONS https://www.seneca.it/products/z-key-mbus/doc/CE_declaration RS485 Comm. (IDC10) INSULATION MeterBUS RS485/232 Power Supply 1500 Vac Temperature: -25 °C –...
  • Page 3 To access the maintenance Web Server with 192.168.90.101 factory IP address enter: http://192.168.90.101 Default user: admin, Default password: admin N.B.: For the Z-KEY-MBUS-P version it is first necessary to activate webserver mode CAUTION DO NOT USE DEVICES WITH THE SAME IP ADDRESS IN THE SAME ETHERNET NETWORK.
  • Page 4 MeterBUS is a non-polarized bus. For the connection it is possible to use a two-wire shielded telephone cable or an unshielded duplex cable following the indications in the table. If a shielded cable is used, this must be connected to earth only from the side of the Z-KEY-MBUS instrument. MI00589-1-EN...

This manual is also suitable for:

Z-key-mbus-p

Table of Contents